24 gpm Ultra Violet Water Sterilizer
24 gpm Ultra Violet Water Sterilizer	24 gpm UV Water Purifier This UV 24, 24 gallons per minute point-of-use water disinfection system, is specifically designed to treat microbiologically contaminated ground or surface waters. Our UV 24 water purification system is the most ecological way of treating your water and for pennies a day.

This disinfection system offers a 4-log reduction (99.99%) in bacteria, virus and protozoan cysts (specifically giardia lamblia and cryptosporidium). The Sterilight process is quick, simple, inexpensive and environmentally friendly as it does not add anything to your water and creates no disinfection by-products.

Applications include private wells, camp grounds, hotels, bottlers, aquaculture, hospitals, food, cottages, restaurants, breweries, water systems, laboratories, marine, pharmaceutical, dairies and many other applications.

Features:

• 26 gpm flow rate at a UV dose of 30 mJ/cm2
• Hard Glass, low pressure mercury vapour lamps with high isolation pin design
• 316L stainless steel reactor chambers, brilliantly polished for laboratory or medical applications
• 1" MNPT connections for installation conformity
• drain port for reactor chamber flushing
• Easy servicing - no need to disconnect water flow to change UV lamp
• New "easy access" aluminum base for quick and easy servicing
• Open end quartz sleeves and aluminum gland nuts for optimum operating temperature and sealing efficiency
• 99.99% destruction of bacteria, virus, and protozoan cysts (Giardia lamblia & cryptosporidium) at rated flow
• Natures way to protect your water without the addition of harmful chemicals
• Seven year warranty on reactor chamber for unparalleled protection
• Visual and audible alarms
• Product certified by CSA (C US) and to CE standards

Installation Manual

Installation Procedure:

1. Note the direction of the water flow in the supply line to which the unit is being connected (Left to Right).

2. Refer to the appropriate plumbing diagram and check to see that you have all the necessary fittings.

3. Shut off main water supply valve.

4. Fasten unit to the wall using the screws provided.

5. Install new plumbing as per diagram. If you are installing a flow control or pre filters, make sure the arrows on them point in the same direction as the water flow.

6. When plumbing new plumbing has been installed, a seal should be attached to the closed by-pass valve. This seal should not be broken unless water is required during emergency or shut-down periods.

7. Plug power cord into the appropriate power source outlet (power source voltage may vary depending on location.

8. Open main valve to water source.

9. Open valve on either side of the sterilizer. (By-pass valve should remain closed) You should hear a sudden rush of water entering the unit at this time. Turn off any faucet that will start the flow of water through the unit.

Warranty:

The S24Q-PA water disinfection systems carry a seven year warranty on the stainless steel reactor chamber, a one year warranty on UV lamps, and a five year pro rated warranty on all other components.